CCI HR/30 Ink Degradent
HR-30 is a water soluble screen wash designed for the removal of all inks, including plastisol and UV inks. HR-30 works especially well on tough inks such as water base, vinyl epoxy and enamels. HR-30 can also be used for the removal of stubborn cured ink stains (ghost or haze).
MANUALLY: Card excessive ink from the screen. Spray or apply manually to the ink side of the screen. Agitate both sides of the screen with a non-abrasive brush or pad and allow product to penetrate. Starting at the bottom of the screen, rinse off all reisdue with high pressure water.
RECIRCULATING: Card excessive ink from the screen. HR-30 can be continuously re-circulated until product becomes too heavily soiled with solids. Used product may be filtered and reused.
CURED INK REMOVER (STAIN): Remove the ink and emulsion from the screen. Spray or apply manually to both sides of the screen. Scrub both sides of the screen with non-abrasive brush or pad. Allow product to remain on the screen for a minimum of 3 minutes. Starting at the bottom of the screen, high pressure water rinse both sides of the screen. *Dispose of in accordance with state, local and federal regulations. Check with your local sanitation district regarding limitations on inks that are to be rinsed into the drain.