International Coatings 150 Silver Glitter Plastisol Ink
IC-150
Metallic Glitters are press ready plastisol ink used for creating special sparkling effects on garments.
FEATURES
Metallic Glitters are used to produce a bright, glittered look when printed.
Metallic Glitters consist of a coarse, shimmering glitter flakes in a low bleed, low fusion, easy to print base.
IMPORTANT INFORMATION
Metallic Glitters can be printed onto a garment as is, or printed over other colors to highlight areas of a design. When printing multiple colors, Glitters should be printed last. Glitters should be printed without any modifications. If modification is necessary use the following reducer: 1099 Low Bleed Curable Reducer (Add 1% to 5% by weight).
Use International Coatings’ 7500 Series Fluorescents or Process Colors for tinting Glitters to other shades. Do not mix Glitters with opaque inks as they will block out or cover the Metallic Glitter flakes.
For better adhesion on some fabrics it may be necessary to add the 900 Catalyst for proper adhesion. The ratio of ink to catalyst is 16 parts ink to 1 part catalyst by volume and 20 to 1 by weight.
When printing Metallic Glitters over the top of other colors or puff ink, it is best to flash dry the underlying colors.
Print Metallic Glitters last in the design to avoid excessive pick-up of the glitter flakes.
The time/temperature cycle is very important when printing through very open mesh screens. It may take the thicker ink film a little longer to reach the proper fusion temperature than a standard ink. Always test for proper fusing before and during a production run.
RECOMMENDED FABRICS
100% Cotton
Cotton/Polyester Blends
Some 100% Polyesters
SCREEN MESH
24-36 t/in (9-14 t/cm) monofilament
SQUEEGEE
60-70 Durometer Sharp edge
CURE TEMPERATURES
325ºF (163ºC) for 1 minute dependent on dryer speed and temperature settings
STORAGE OF INK CONTAINERS
65º to 90ºF (18ºC to 32ºC)Avoid storage in direct sunlightKeep containers well sealed
Feel free to live chat with us if you have any questions.