International Coatings 717 Ultimate Black FlexCure Plastisol Ink
717 Ultimate Black™ is a non-phthalate, high pigment, fast flashing, low tack, high performance plastisol screen printing ink.
717 Ultimate Black™ provides a deep black color that is very creamy, short bodied and is easy to print on automatic or manual presses.
717 Ultimate Black™ achieves excellent penetration into fabrics when printing through fine mesh counts.
717 Ultimate Black™ will spot dry, with a very low after flash tack. Dwell time is dependent on the spot dryer used. In some cases, you may have to lower the heat of the spot cure unit because too much heat may actually make the ink tacky. When you spot dry, you are only partially fusing or gelling the surface of the ink. The ink should be just dry to the touch, with no lift-off, but not totally fused. Final fusing or curing should occur in the dryer
717 Ultimate Black™ was formulated to make printing opaque black easy, so hand printing is less tiring. The result is improved operator performance. Automatic equipment can be adjusted to lower pressure settings, thus improving screen life and squeegee durability.
50/50 Cotton/Polyester Blends
60-230 t/in (24-90 t/cm) monofilament
60-70 Durometer Sharp edge
275ºF-325ºF (135ºC-163ºC) entire ink film
STORAGE OF INK CONTAINERS
65º to 90ºF (18ºC to 32ºC) Avoid storage in direct sunlight. Keep containers well sealed
Feel free to live chat with us if you have any questions.